Go to the first, previous, next, last section, table of contents.


Using the E7000 in-circuit emulator

You can use the E7000 in-circuit emulator to develop code for either the Hitachi SH or the H8/300H. Use one of these forms of the `target e7000' command to connect to your E7000:

target e7000 port speed
Use this form if your E7000 is connected to a serial port. The port argument identifies what serial port to use (for example, `com2'). The third argument is the line speed in bits per second (for example, `9600').
target e7000 hostname
If your E7000 is installed as a host on a TCP/IP network, you can just specify its hostname; uses telnet to connect.


Go to the first, previous, next, last section, table of contents.