Go to the first, previous, next, last section, table of contents.
- Command: pow_detach
-
(C-a D)
Mainly the same as detach
, but also sends a HANGUP signal
to the parent process of screen
.
Caution: This will result in a
logout if screen
was started from your login shell.
- Command: pow_detach_msg [message]
-
(none)
The message specified here is output whenever a power detach is
performed. It may be used as a replacement for a logout message or to reset
baud rate, etc.
Without parameter, the current message is shown.
Go to the first, previous, next, last section, table of contents.